High-Efficiency Heat Pump Systems for Papillion Homes

We start with a detailed walkthrough of your home. We measure square footage, assess insulation quality, check ductwork layout and condition, identify air leaks around windows and doors, and examine your current equipment. Upon request or depending on your system, we'll conduct a load calculation to find your home's heating and cooling load—the amount of capacity needed to maintain comfort across Nebraska's temperature range, from summer heat to winter cold. This assessment determines which system we recommend. A properly sized system runs efficiently without short-cycling, handles peak heating and cooling demand, serves you reliably for years, and delivers optimal comfort in every room throughout the year.

• Measure home square footage and ceiling heights
• Assess attic insulation, basement conditions, and air sealing
• Inspect existing ductwork for leaks and sizing
• Review your utility bills to understand seasonal heating and cooling demand
• Discuss your comfort preferences and any problem areas in your current system
• Recommend the right equipment size and efficiency level for your home

Based on your home's load and your budget, we present your options: entry-level efficiency equipment, mid-range high-efficiency systems, and premium ultra-efficient options. We explain the efficiency differences, the long-term energy savings, and available financing. We also walk through available rebates—OPPD rebates, Tempstar rebates, and any current manufacturer incentives that apply to your equipment choice. Financing lets you pay over time with convenient monthly payments. Rebates reduce your out-of-pocket investment.

• Present equipment options from entry-level to premium efficiency
• Compare annual energy cost estimates for each option
• Explain available rebates and eligibility
• Review your special financing options
• Answer questions about efficiency ratings and seasonal performance
• Schedule installation once you've chosen your system

On installation day, we remove your old indoor and outdoor units, drain and recover refrigerant per EPA standards, and dispose of all equipment responsibly. We inspect your ductwork—if it needs sealing or repair to support the new system, we address that. We prepare the outdoor pad or mounting point for the new condenser and route new refrigerant lines if needed. This groundwork ensures your new system operates at peak efficiency.

• Safely remove and dispose of old equipment
• Recover refrigerant and document all recovery procedures
• Inspect and seal ductwork leaks
• Prepare outdoor location for new condenser installation
• Run new refrigerant lines if existing lines are inadequate
• Protect landscaping and clean up work areas

We install the outdoor condenser unit on a secure, level pad. We install the indoor air handler (or retrofit it into your existing furnace cabinet if compatible). We run refrigerant lines with proper insulation and routing. We wire all electrical connections, program your thermostat, and set up all controls. We flush the refrigerant system and charge it to exact manufacturer specifications for your equipment model and capacity. Proper charge is critical—even a few ounces of deviation reduces efficiency and system lifespan.

• Install outdoor condenser on level, vibration-isolated pad
• Install or integrate indoor air handler unit
• Run refrigerant lines with full insulation and support
• Complete all electrical connections and safety interlocks
• Program thermostat and control settings
• Evacuate, flush, and charge refrigerant to specification
• Test safety switches and verify all controls

We run your new system through full heating and cooling cycles. We verify air delivery to every room, check thermostat response and scheduling, test defrost operation (important for heat pumps in winter), and confirm all sounds and vibration are normal. We walk you through your new system: how to use the thermostat, when to change filters, what seasonal adjustments to expect, and how to recognize warning signs that signal future maintenance needs. You'll receive complete documentation and know when to schedule your first maintenance tune-up.

• Run system through complete heating and cooling cycles
• Verify temperature delivery and comfort in every room
• Test thermostat programming and response
• Check defrost cycle operation and timing
• Listen for and verify normal operating sounds
• Confirm all electrical and safety interlocks function
• Provide complete documentation, warranty info, and service schedule